Before diving into configuration, ensure your environment meets the following requirements:
Verify that Xray started correctly and connected to the server. /container/logs/print Use code with caution.
I can provide the exact syntax adjustments or targeted script configurations for your setup. Share public link
The first step is to enable the container feature on your router. Follow these commands in order:
In the V2Ray config.json , enable the built-in DNS component to resolve domains on the remote VPS side. Troubleshooting Connectivity Failures v2ray mikrotik
This configuration uses a common private IP range ( 172.17.0.0/24 ), creating a clean separation between your container's traffic and your main LAN.
Set the container directory:
:
Implementing V2Ray on MikroTik RouterOS: A Complete Guide Network censorship, strict firewalls, and deep packet inspection (DPI) present significant challenges for maintaining secure, open internet access. Traditional VPN protocols like OpenVPN or WireGuard are easily identified and blocked by advanced firewalls. Share public link The first step is to
]
This is where you decide which traffic gets sent through your proxy. You can mark traffic based on various criteria.
Since MikroTik’s RouterOS does not natively support the V2Ray protocol suite, the implementation typically follows one of two paths: (on ARM/x86 hardware) or Transparent Proxying via a secondary gateway. 1. Implementation Methods
/ip firewall address-list add address=netflix.com list=PROXY_DOMAINS /ip firewall address-list add address=www.youtube.com list=PROXY_DOMAINS Set the container directory: : Implementing V2Ray on
In this setup, a secondary lightweight device (like a Raspberry Pi, a Linux VPS, or a Docker container) runs the V2Ray client configured as a transparent proxy using dokodemo-door or TProxy . The MikroTik router acts as the traffic director, using Policy-Based Routing (PBR) to intercept specific network traffic and forward it to the V2Ray gateway machine before it hits the internet. 2. Native RouterOS v7 Containers
/container/mounts add dst=/etc/x-ui/ name=x-ui src=/x-ui/db /container/mounts add dst=/root/cert/ name=cert src=/x-ui/cert
A common issue with V2Ray on routers is DNS hijacking or DNS leaking, which reveals your real location.
Always use a high-end, high-endurance USB flash drive or microSD card for the /container/root-dir path.
This is a popular and user-friendly option that provides a complete management panel for your proxy. It simplifies user management and traffic monitoring.
# For RouterOS v7: Define the routing table and add the route /routing/table/add name=to_v2ray fib /ip/route/add dst-address=0.0.0.0/0 gateway=192.168.88.254@main routing-table=to_v2ray Use code with caution. Optimizing V2Ray on MikroTik DNS Leak Prevention