The V2000-C is a widely used, standalone RFID access control keypad designed for secure and reliable entry management. This comprehensive guide serves as an extended user manual, detailing the technical specifications, wiring configurations, and step-by-step programming instructions for the device. 1. Product Overview and Technical Specifications
Press 5 , flash the new EM RFID Card past the sensor reader lens, and press # . Enroll Card by Index Number: Press 5 →right arrow Enter a 3-digit slot index (e.g., 001 to 999 ) →right arrow Swipe the card →right arrow Press # . Enroll a 6-Digit Common Pin: Press 6 →right arrow Enter New 6-Digit PIN Code →right arrow Press # →right arrow Re-enter PIN Code →right arrow Press # . Deleting User Access V2000-c Access Control Manual - Facebook
Press and hold down the # key (or the reset button located on the back PCB, depending on production batch). the device while continuing to hold the key. Release the key after hearing a series of short beeps.
If you need help setting up a specific configuration, please let me know: V2000-c Rfid Access Control User Manual
Re-enter the to verify, then press # . Step 3: Setting the Access Mode
(Invoking related search terms...)
is a popular, cost-effective, and standalone security solution designed for homes, offices, and small commercial sites . It combines a durable keypad with a proximity card reader, allowing for access via PIN, RFID fob/card, or a combination of both. The V2000-C is a widely used, standalone RFID
V2000-c RFID Access Control User Manual: Comprehensive Programming and Installation Guide V2000-c RFID Access Control Keypad Go to product viewer dialog for this item.
Open Button (PUSH) – Connects to an exit button terminal; the other side of the button goes to GND. Purple: Bell+ (Doorbell interface) Blue: Bell- (Doorbell interface) Standard Wiring Layout
Always change the default Master Code immediately after installation to prevent unauthorized access to your programming settings. Product Overview and Technical Specifications Press 5 ,
A: 500 users (500 RFID cards or 500 PIN codes, or a mix).
End of the V2000-c RFID Access Control User Manual.
For users managing a large number of access credentials:
Press * + 999999 + # . (The indicator light will turn orange/flashing). Exit Programming Mode: Press * .
Check your relay wiring. Ensure Fail-Safe locks use the NC wire and Fail-Secure locks use the NO wire.
