Leica Tcr805 Total Station User Manual [ EASY ]

Connect the instrument to a computer using a Leica GSI-to-USB or RS232 serial cable.

Turn on the electronic laser plummet to position the instrument directly over your ground point. Use the tripod legs to center the circular bubble.

Look at the ground mark and adjust the tripod legs until the laser dot sits precisely in the center of your ground nail or monument.

A small icon indicates whether the EDM (Electronic Distance Measurement) is set to IR (Infrared Prism mode) or RL (Reflectorless mode). 3. Step-by-Step Instrument Setup

Select the export format—typically (Leica's native format) or DXF for direct CAD plotting. leica tcr805 total station user manual

Ensure the communication settings (Baud rate, Data bits, Parity) on your PC software match the settings inside the TCR805 menu (Standard is usually 9600 Baud, 8 Data Bits, No Parity).

Uses rechargeable Leica GEB111 or GEB121 NiMH batteries. 2. Setting Up the Instrument

Press the key to save the angles and distances to the memory.

Are you looking to perform a with this manual (e.g., topo mapping, construction stakeout, or boundary surveying)? Connect the instrument to a computer using a

Controls system settings, data management, and calibration.

: Define a line between two points to measure offsets. 3. Data Management & Transfer Leica Total Station 805

Enter your station coordinates (Northing, Easting, Elevation) or pull them from your saved job memory. Input the instrument height.

This public link is valid for 7 days and shares a thread, including any personal information you added. This link or copies made by others cannot be deleted. If you share with third parties, their policies apply. Can’t copy the link right now. Try again later. Look at the ground mark and adjust the

Because the TCR805 utilizes an older generation architecture, data transfer requires specific hardware configurations.

Secure the TCR805 onto the tripod head using the central fixing screw. Step 2: Levelling using the Circular Bubble Turn on the instrument to activate the electronic guide.

: Use the horizontal and vertical drives for fine pointing at your target. 3. Measuring and Distance Modes (EDM)