Harvey Hv3 Water Softener Installation Manual Official

Follow the app prompts to connect the unit to your WiFi network. 4. Testing BLOCK SALT SOFTENER INSTALLATION INSTRUCTIONS

Open the main stopcock slowly to check for leaks.

: The Harvey HV3's twin-cylinder design ensures a continuous supply of soft water—unlike single-tank electric softeners that supply hard water during regeneration cycles. harvey hv3 water softener installation manual

Incoming dynamic pressure must be between a minimum of 1.7 Bar and a maximum of 6.0 Bar . If your pressure exceeds 5 Bar, install a pressure-reducing valve.

Both the inlet and outlet threaded connections can be removed by unclipping the retaining clips to facilitate an easier hose connection. After fitting the hoses, always remember to reinsert the clips to secure them firmly in place. Follow the app prompts to connect the unit

Before starting, be aware of the following requirements:

The bypass valve allows you to divert water around the water softener during maintenance or regeneration. Connect the bypass valve to the inlet and outlet pipes. : The Harvey HV3's twin-cylinder design ensures a

Your Harvey HV3’s bypass system typically consists of three valves: , Outlet , and Bypass .

Open the top lid of the Harvey HV3 and place two blocks of Harvey water softener salt into the loading compartments.

The Harvey HV3 water softener installation manual dedicates an entire section to pre-installation planning. Do not skip this page. Here is what you need to confirm:

Most likely because the hardness dial is set too high, or the water meter is sticking. See Section 6 of the manual for recalibration.