0.16 feet to 165 feet (0.05 meters to 50 meters) Measurement Accuracy: ±1/16 inch (±2mm) Laser Class: Class II, Laser Wavelength: 630–670nm
Press and hold the button (often labeled with a U or a ruler icon) for approximately 2–3 seconds.
Use this mode to measure heights of walls or structures from a distance when direct access is blocked.
): Press the button twice until the 3D cube icon appears. Measure the Length , Width , and Height sequentially using the MEAS button. The final total volume will calculate automatically. Pythagorean Measurements (Indirect Measuring) dtape dt50 user manual pdf
Press the button three times until a right-triangle icon appears.
Switches between Area, Volume, and Pythagorean theorem measurement modes.
The DTAPE DT50 automatically calculates and displays the total area. 4. Volume Calculation ( ft3ft cubed Press the button twice until the cube icon appears. Measure the Length , Width , and Height
Press the button once until the rectangle icon appears on the screen. Press Read to measure the length. Press Read to measure the width.
Repeat the long press until your preferred unit system appears on the screen. Adjusting the Reference Point
Keep the lens clean. Use a soft, damp cloth to clean the casing. Do not immerse in water. Safety Guidelines Do not stare directly into the laser beam. Do not operate in explosive or dangerous environments. Keep out of reach of children. Need the manual? Please Use a soft
The DT50 is more than just a digital ruler. It uses phase-shift technology to calculate distances up to 50 meters (approximately 165 feet).
Search for "DTAPE official website" to find support documents.
