Daikin Brc1c51 61 Installation Manual !link! 〈FRESH | 2027〉

[ Upper Case (Main Body) ] │ ▼ (Snaps into place) [ Back Plate (Mounting Base) ] ──► Secured to Wall/Junction Box via 2 Screws │ ▼ [ Field Wiring: P1, P2 ] Step 1: Open the Casing

Once the BRC1C61 is installed and powered on, you can configure the basic settings. Most controls on the BRC1C61 are hidden behind a at the bottom half of the controller. To access them, gently pull down on the finger grip located on the top right edge of the door.

it in direct sunlight or near heat sources (lamps, appliances).

Route the 2-core control wire through the conduit or switch box in the wall, pulling it out through the large center opening of the rear installation plate. Step 3: Secure the Rear Installation Plate daikin brc1c51 61 installation manual

Total bus length must not exceed 1,640 feet (500 meters) . Terminal Connections

Check the circuit breaker and ensure the wires are securely connected to the terminal block (

Route the other end of the cable to the indoor unit's control PC board and connect it to the corresponding and P2 (Remote Controller) terminals. 5. Field Settings and Commissioning [ Upper Case (Main Body) ] │ ▼

Ensure all power supplies to both the indoor unit and outdoor unit are fully at the circuit breaker.

Connect both controllers in parallel to the P1 and P2 terminals of the indoor unit. Final Assembly and Commissioning

Installing the wired remote controller requires careful physical mounting and precise electrical wiring to ensure the HVAC system operates correctly. This guide summarizes the critical steps for a standard installation based on Daikin technical documentation . 1. Preparation and Safety it in direct sunlight or near heat sources

Mount the device on an interior wall approximately 5 feet (1.5 meters) above the finished floor to sample a representative average room temperature.

Once the physical installation is complete, the controller must be initialized to communicate with the indoor unit. Restore power to the indoor unit. Initialization:

Chargement en cours ...