Caraflo V200 Shower Instructions Jun 2026

| Problem | Possible Cause | Solution | | :--- | :--- | :--- | | | Power source issue (dead batteries) or no water supply. | Replace batteries (usually AA inside the control box) or check main water valves. | | Water is too cold | Hot water supply cut off or inlet filters blocked. | Check if the water heater is working. Clean the hot water inlet strainer. | | Temperature fluctuates | Unbalanced water pressure or dirty thermostatic cartridge. | Ensure no other appliances (washing machine/toilet) are using water simultaneously while showering. Clean cartridge. | | LED Display fading | Low battery voltage. | Replace batteries immediately to prevent the valve from sticking in the "open" position. | | Water drips after shut off | Residual water in the pipe. | This is normal for a few seconds. If it persists, the internal solenoid valve may need cleaning or replacement. |

The Caraflo V200 is a popular, compact thermostatic mixer valve widely used in caravans, motorhomes, and static holiday homes. This guide provides clear, step-by-step instructions to install, operate, and maintain your Caraflo V200 shower safely and efficiently. Technical Specifications

The V200 is designed to mount directly through a caravan shower wallboard panel. Follow these steps for a secure, leak-free installation:

For reference, here are the official technical specifications of the Caraflo V200: caraflo v200 shower instructions

The Caraflo V200 is a popular, compact thermostatic mixer valve widely used in caravans, motorhomes, and boats. It is highly valued for its ability to maintain a constant water temperature despite fluctuations in supply pressure.

Before beginning any physical work, verify that your pipe setup matches the structural blueprint of the V200: Specification Dimension / Standard Orientation Options Dual-orientation (Horizontal or Vertical) Valve Height 165mm (when oriented vertically) Valve Width Depth From Wall Threaded Tail Length Tail Outlet Diameter Regulatory Approvals NCC Certified, WRAS Approved, TMV2 Scheme Approved Installation Instructions

: Insert the provided rubber seals into the union nuts before tightening them onto the brass tails. | Problem | Possible Cause | Solution |

If the cartridge is covered in white limescale, soak it in a 50/50 solution of warm water and white vinegar for 30 minutes. Rinse thoroughly.

The internal flow control cartridge is worn out or damaged by limescale.

comes factory-set, but variances in caravan combi-boilers or site water pressures often require manual calibration. | Check if the water heater is working

To maintain the appearance and function of the Caraflo V200:

Take out the wire mesh filters located inside the hot and cold inlets.

is designed to replace the older V100 model without needing modifications The Caravan Warehouse Orientation : It can be installed in either a horizontal or vertical Pipe Centers : It features standard 45mm pipe centers Water Connections : Connect the water supply to the inlet marked "H" (or red label) and the supply to the "C" inlet (or blue label). Preparation

: Ensure your caravan water pump or site supply provides balanced hot and cold pressures. 2. Mounting the Valve